[. . . ] ¢ Do not let persons, children included, with reduced physical sensory, reduced mental functions or lack of experience and knowledge use the appliance. They must have supervision or instruction for the operation of the appliance by a person who is responsible for their safety. ¢ Keep children and pets away from the appliance door when it is open. ¢ If the water inlet hose is damaged, immediately disconnect the mains plug from the mains socket. [. . . ] ¢ Press the multitab button, the related indicator comes on. If you stop to use the combi detergent tablets, before you start to use separately detergent, rinse aid and dishwasher salt, do these steps: 1. Make sure that the salt container and the rinse aid dispenser are full. Start the shortest programme with a rinsing phase, without detergent and without dishes. 1 Energy Saver
This option decreases the temperature in the drying phase. Press the Energy Saver button: ⢠If the option is applicable to the programme, the related indicator comes on. ¢ If the option is not applicable to the programme, the related indicator flashes for some seconds and then stays off. 2 Multitab
Activate this option only when you use the combi detergent tablets. Make sure that the set level of the water softener agrees with the water hardness in your area. Contact your local water authority to know the water hardness in your area. Manual adjustment
Turn the water hardness dial to the position 1 or 2. Press and hold buttons (8) and (9) at the same time until the programme indicators above buttons (8), (9) and (10) flash. ¢ The programme indicator above button (10) continues to flash. ¢ The display shows the setting of the = levwater softener. Fill the rinse aid dispenser (A), no more than the mark 'max'. Remove the spilled rinse aid with an absorbent cloth to prevent too much foam. You can turn the selector of the released quantity (B) between position 1 (lowest quantity) and position 4 (highest quantity). Make sure that the appliance is in setting mode, refer to âSETTING AND STARTING A PROGRAMMEâ. ¢ If the rinse aid indicator is on, fill the rinse aid dispenser. Set and start the correct programme for the type of load and the degree of soil. If the programme has a prewash phase, put a small quantity of detergent on the inner part of the appliance door. ¢ The display shows the programme duration that decreases with steps of 1 minute. [. . . ] Stains and dry water drops on glasses and dishes ⢠The released quantity of rinse aid is not sufficient. Dishes are wet ⢠The programme is without a drying phase or with a low temperature drying phase. ¢ The quality of the combi detergent tablets can be the cause. Try a different brand or activate the rinse aid dispenser and use rinse aid together with the combi detergent tablets. [. . . ]